RavenVT100
Member
- Joined
- Aug 18, 2004
- Messages
- 1,107
I figured I'd start a thread here because many people bought the CDNN FN PBR and wanted to know how to install the stock.
The receiver came with two screws, both with a locking compound applied. I tightened them down on the stock with an allen key, then snugged it down a bit with the long end of the key. It's not super tight, but tight enough that I can't get them out with the short end.
The question I have is whether this is sufficient or if I should break out the FAT wrench and go to a specific in-lbs value.
The receiver came with two screws, both with a locking compound applied. I tightened them down on the stock with an allen key, then snugged it down a bit with the long end of the key. It's not super tight, but tight enough that I can't get them out with the short end.
The question I have is whether this is sufficient or if I should break out the FAT wrench and go to a specific in-lbs value.