chris93555
Member
I have been having problems sizing .223 cases using Hornady's sizing die. As you can see from the picture at the end of the case it makes a ledge, but it only does it the one side of the case. Also it only does it with mil brass, ie WC, LC brass. I use Hornady's One shot case lube. I used to use Lee Dies and didn't have this problem. I made sure there was nothing stuck inside the die. I'm also using this die on a Hornady LNL progressive press. I have had this problem ever since I used this die. Has anybody else run into this problem? Do I have a bad die?