Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hornady die question

Discussion in 'Handloading and Reloading' started by Odessa, Jan 1, 2003.

Thread Status:
Not open for further replies.
  1. Odessa

    Odessa Member

    Joined:
    Dec 28, 2002
    Messages:
    46
    Location:
    eastern NC
    Was out loading some .41 Mags and noticed that my Hornady seating/crimping die has a loose fitting seater adjustment screw. The O-ring is present and looks intact, but doesn't appear to be thick enough to engage the internal threads on the die body. Would some type of pipe thread compound help hold the seater adjustment screw in place? As I seat and crimp the adjustment screw moves a bit each time and gets out of adjustment after about 5-7 rounds - it is a pain to have to keep resettinig it (wish Hornady had seen fit to use a lock-nut like the other brands of dies I own). Open to any suggestions. Thanks, Odessa
     
Thread Status:
Not open for further replies.

Share This Page