RustyShackelford
member
- Joined
- Apr 27, 2006
- Messages
- 4,018
Howdy gang;
Any input on how to remove nicks, scratches and wear marks from a stainless steel Ruger GP-100 DA revolver?
My duty GPNY 4" .38spl fell on a concrete surface, while I pumped gas into my patrol car and now has a few small nicks in the cylinder. :banghead:
I was thinking about steel wool or maybe a dremel tool to smooth out the nicks. I'd think the minor holster wear marks from my kydex Bladetech holster could be removed too. The wear marks are along the GPNY's barrel.
PM me or post here.
Thank you;
Rusty
PS: I'm also thinking about a Robar NP3 plate job later on down the road but want to remove these scratches first. www.robarguns.com
Any input on how to remove nicks, scratches and wear marks from a stainless steel Ruger GP-100 DA revolver?
My duty GPNY 4" .38spl fell on a concrete surface, while I pumped gas into my patrol car and now has a few small nicks in the cylinder. :banghead:
I was thinking about steel wool or maybe a dremel tool to smooth out the nicks. I'd think the minor holster wear marks from my kydex Bladetech holster could be removed too. The wear marks are along the GPNY's barrel.
PM me or post here.
Thank you;
Rusty
PS: I'm also thinking about a Robar NP3 plate job later on down the road but want to remove these scratches first. www.robarguns.com