Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How hard is it to remove and AR-10 Flash Suppressor?

Discussion in 'Rifle Country' started by shield20, Nov 16, 2007.

Thread Status:
Not open for further replies.
  1. shield20

    shield20 Member

    Joined:
    May 21, 2005
    Messages:
    789
    Location:
    New York
    How hard is it to remove an AR-10 Flash Suppressor?

    Title says it all - I was thinking about replacing the flash suppressor on an AR-10A4 - how hard is it to get that off? (I am assuming it is just threaded on there).

    Thanks!
     
    Last edited: Nov 16, 2007
  2. Zak Smith

    Zak Smith Moderator Emeritus

    Joined:
    Dec 24, 2002
    Messages:
    9,043
    Location:
    Fort Collins, CO, USA.
    If it is just screwed on, then you can unscrew it with the right tool. If it's locktited, apply heat to break the loctite.

    If it's been pinned, you need to locate the blind pin and grind it off/out.

    -z
     
Thread Status:
Not open for further replies.

Share This Page