I recently obtained some Hornady 240 gr swaged lead .430 bullets.
They're sort of knurled all over, waxed & lack any crimping groove.
So far, I succeeded in developing an accurate, light target load in .44 Spl, seating the bullet rather deeply & taper-crimping them.
Would taper crimping be sufficient for heavier loads ?
How would YOU crimp them ?
They're sort of knurled all over, waxed & lack any crimping groove.
So far, I succeeded in developing an accurate, light target load in .44 Spl, seating the bullet rather deeply & taper-crimping them.
Would taper crimping be sufficient for heavier loads ?
How would YOU crimp them ?