hey everyone
i have had this issue on other loads, just reloaded this batch with my new rcbs rockcrusher press so i dont think the press is the issue
reloading 7 mm rem mag, speer 160 grain boat tail bullets,
after trimming cases ,priming and charging i seat my first bullet to 2.80 , loaded the rest of a 10 batch and the coal is anywhere from 2.72 to 2.82
i went by the instrctions to a t for the lee dies. i am at starting load so i (hope) this will not be a safety issue, but the big thing is i cant figure out why
any help would be appreciated,
i have noticed that the lee die seats the bullet from the tip , is there any thought to a die that seats from the ogive, would that produce more consistant results
thanks again
i have had this issue on other loads, just reloaded this batch with my new rcbs rockcrusher press so i dont think the press is the issue
reloading 7 mm rem mag, speer 160 grain boat tail bullets,
after trimming cases ,priming and charging i seat my first bullet to 2.80 , loaded the rest of a 10 batch and the coal is anywhere from 2.72 to 2.82
i went by the instrctions to a t for the lee dies. i am at starting load so i (hope) this will not be a safety issue, but the big thing is i cant figure out why
any help would be appreciated,
i have noticed that the lee die seats the bullet from the tip , is there any thought to a die that seats from the ogive, would that produce more consistant results
thanks again