llwsgn
Member
hello there! i'm taking my 3 screw super blackhawk to hunt a doe in a couple of weeks. i had it to the range to get warmed up with it. i'm planning on shooting it every few days till the tag opens up. anyway, question is, as i was cleaning following a range trip i noticed that one of the two rear screws on either side of the hammer had backed outward some. i snugged it, (about 3 turns) then checked/snugged, the others. every screw took some tightening, particularly the biggest one through the hammer. that was a mistake the hammer would only draw back about half way after tightening that screw. is there a system as to how to go about this? it wouldn't seem that they should be backing out, but everything snug is obviously not what i'm after here either. does anyone have some advice?
thanks!
thanks!
Last edited: