I am almost done with this measure. Today I set it up on my turret looking to load 25.0 h335 in 223. I got it set and had decent consistency but it was leaking more than I could handle. I tried tighter, loser but nothing slowed the leak down. I switched over to a lee ppm and continued on charging cases off the press. The ppm leaks a few grains but not bad. Has anyone else tried h335?
Day before i was trying to load 5.0 bullseye and got variance of 4.4 to 5.2. If I held the press ram in full extension and jiggled the drum i got more consistent 4.9 charges everytime. Got tired of that and put autodisk on and problem solved, got charges of 4.9'to 5.1.
I am a full lee supporter as 90% of my equipment is lee but this powder measure is killing me.
Sorry but are small grain powders like 335 just not suited for this measure?
Day before i was trying to load 5.0 bullseye and got variance of 4.4 to 5.2. If I held the press ram in full extension and jiggled the drum i got more consistent 4.9 charges everytime. Got tired of that and put autodisk on and problem solved, got charges of 4.9'to 5.1.
I am a full lee supporter as 90% of my equipment is lee but this powder measure is killing me.
Sorry but are small grain powders like 335 just not suited for this measure?