twinhairdryers
Member
- Joined
- Feb 7, 2006
- Messages
- 147
So I bought a new Lee powder measure tool (the red plastic with the pull handle. My old one works ok, but I replaced the center screw and it is loosy goosy and just cracked the powder housing, so thought I would replace. I know my original one must have been 10 years old, and when I would load a shell, there would always be about 5-15 single grains of powder that spilled out of some mystery hole. My NEW from the box powder kit drops what must be a tenth of a grain of powder out loose that doesn't get into the shell (from some mystery hole again). It is so bad, I am loading on a piece of paper so I can put the spilled powder back in. What adjustment does this need to not spill so much loose powder?? My repeatability of loads is still not too bad (0.1 grain or less), but loosing that much random spilled powder seems like something is very wrong. how do i adjust this thing? thanks!