Dudedog
Contributing Member
Glad it worked for you.
I have addressed that by removing the O-ring between the measure and the riser. It was enough to eliminate the ledge.For dropping small powder charges more consistently, many modify the charge bar to move the small oval/football shaped opening over the powder drop tube by adding epoxy/bondo -
Yes, but OP needed to drop small charges of Titegroup at 3.1 gr.Adjustable charge bar cannot drop very small charges consistently.Did anyone mention the Adjustable Charge Bar?
No need. You modify the disk you are already using. If you need the full capacity of the hole, you just back out the screw. If you need to use other holes, you remove the screw.you need to buy an extra disk.
So far so good ... drilled a hole in the .30 hole. Found a small non-brass screw and inserted it. Backed it out and tapered/filed the end. Put it back in and dialed it in to 3.1 gr with Titegroup. Did 6 or 7 tests and it's consistent @ 3.1. ... I'm good to go.wanting to load 3.1 gr Titegroup
I know you can do that but if you are loading a lot of the same ammo all the time I would want to leave the disk set to the correct drop. I like things simple and and easy.No need. You modify the disk you are already using. If you need the full capacity of the hole, you just back out the screw. If you need to use other holes, you remove the screw.
I know you can do that but if you are loading a lot of the same ammo all the time I would want to leave the disk set to the correct drop. I like things simple and and easy.