BigSlick
Member
Hi guys,
I just loaded a few rounds of 500SW.
When going thru loaded round inspection, I noticed one piece of Corbon brass had an odd anomoly.
I pulled the round, and the same is on the inside of the brass, with interior and exterior edges raised enough to catch a finger nail or dental pick on.
I haven't fired the brass in my 500, I just bought this batch of 100 from brassman.
I don't know what would cause something like the ring, but it looks like it was a 'filler' piece of some sort.
I'm not going to fire this for sure. I went thru the rest of the brass with a magnifying glass under a bright light and none of the others exhibit the same marking.
What causes this ?
Just a reminder to be thorough in your round inspection, I can't imagine what a KB would be like with 42gr of H4227
Opinions ?
Thanks
BigSlick
I just loaded a few rounds of 500SW.
When going thru loaded round inspection, I noticed one piece of Corbon brass had an odd anomoly.
I pulled the round, and the same is on the inside of the brass, with interior and exterior edges raised enough to catch a finger nail or dental pick on.
I haven't fired the brass in my 500, I just bought this batch of 100 from brassman.
I don't know what would cause something like the ring, but it looks like it was a 'filler' piece of some sort.
I'm not going to fire this for sure. I went thru the rest of the brass with a magnifying glass under a bright light and none of the others exhibit the same marking.
What causes this ?
Just a reminder to be thorough in your round inspection, I can't imagine what a KB would be like with 42gr of H4227
Opinions ?
Thanks
BigSlick