p5200
Member
- Joined
- Jul 20, 2009
- Messages
- 308
I got this info from Lyman instructions. Is this the way most of you that use this particular die set it up? Thanks! (
Adjusting the T/C die: With the shellholder at its highest pint, turn
your T/C die into the press until the dies’ bottom edge is just the
thickness of a matchbook cover away form the shellholder. Tighten
the die lock ring and the set screw. Your T/C die is ready to use.
Do not turn your T/C die to contact the top of the shellholder!
Carbide is extremely hard material which shatters easily if forced
against a hard surface, such as the shellholder. )
Adjusting the T/C die: With the shellholder at its highest pint, turn
your T/C die into the press until the dies’ bottom edge is just the
thickness of a matchbook cover away form the shellholder. Tighten
the die lock ring and the set screw. Your T/C die is ready to use.
Do not turn your T/C die to contact the top of the shellholder!
Carbide is extremely hard material which shatters easily if forced
against a hard surface, such as the shellholder. )