Kevin5098
Member
- Joined
- Dec 21, 2008
- Messages
- 266
I reported in this forum earlier on a problem I was experiencing with my CMP M1 Garand. The rifle occasionally fired double. I replaced the trigger sear group but continued to have the problem.
When I run a function check with the trigger group removed, the trigger group functions normally - i.e. with trigger held down, the sear engages the hammer hooks when the hammer is cocked rearward, then transfers to forward hooks when trigger is released. Trigger group also functions normally when installed in stock (new CMP stock) without barrel and receiver. The rifle fails the function check when everything is assembled, however. This leads me to believe that the problem is still present.
Any ideas as to what is wrong and how to correct? Thanks in advance.
Kevin
When I run a function check with the trigger group removed, the trigger group functions normally - i.e. with trigger held down, the sear engages the hammer hooks when the hammer is cocked rearward, then transfers to forward hooks when trigger is released. Trigger group also functions normally when installed in stock (new CMP stock) without barrel and receiver. The rifle fails the function check when everything is assembled, however. This leads me to believe that the problem is still present.
Any ideas as to what is wrong and how to correct? Thanks in advance.
Kevin