Dave Markowitz
Member
Today I was able to get to the range and shoot the Marlin 1894 that I traded for last week. This rifle bears a Remington proof mark on the barrel and the serial number on the left side of the receiver, indicating it was made after Remington moved Marlin's production line to Illion, NY.
I setup an IDPA target with a 3" orange dot in the center at 25 yards. Shooting with my arms rested on the bench but the rifle otherwise unsupported, I fired a 5 shot group. It was a few inches low and slightly to the left. Getting the point of impact to coincide with the point of aim required me to raise the rear sight two notches on the rear sight elevator.
To adjust windage you need to drive the rear sight to the side in the dovetail. To move the POI right you drift the rear sight to the right, and vice-versa. This isn't a precise process, and requires you to use a non-marring mallet, or a hammer and a brass or nylon punch. I had a nylon faced mallet and gave the rear sight base a couple taps to the right. I wound up smacking it a little to far and had to drive it a little bit to the left. For now, it's shooting dead on at 25 yards.
I tried two kinds of .44 Magnum ammo in this trip. First was some of the Federal American Eagle 240 grain JHP that I bought when I got the gun. This ammo shoots OK and groups well, but does not feed smoothly. I really had to muscle the action when shooting it, which gave me some cause for concern. Having read some complaints about Marlin's quality since the Remington takeover and move to Illion, NY, I was bit worried that it might need a trip back to the factory.
However, when I switched to some Remington 240 grain JSP loads the Marlin's action worked a lot more smoothly. I figure that the Federal cases vary in some small dimension that the Marlin doesn't like. The ogives of the Remington and Federal bullets are very similar.
I've picked up a good supply of the Remington ammo so I'm set for awhile. I plan to start handloading for the Marlin so I can afford to shoot it. Also, I intend to load down the .44 Mag to .44-40 velocities, which will make it more pleasant to shoot. The Marlin has a rubber butt pad but even so, after 70 rounds of .44 Mag in a 6.5 pound rifle, my shoulder was feeling tenderized.
Overall I'm pleased with the Marlin 1894. The .44 Magnum is a versatile round, the rifle is nice, compact, and quick shooting, and of course it's got an all-American cachet. I will be adding an aperture sight at some point for faster target acquisition and better accuracy.
I setup an IDPA target with a 3" orange dot in the center at 25 yards. Shooting with my arms rested on the bench but the rifle otherwise unsupported, I fired a 5 shot group. It was a few inches low and slightly to the left. Getting the point of impact to coincide with the point of aim required me to raise the rear sight two notches on the rear sight elevator.
To adjust windage you need to drive the rear sight to the side in the dovetail. To move the POI right you drift the rear sight to the right, and vice-versa. This isn't a precise process, and requires you to use a non-marring mallet, or a hammer and a brass or nylon punch. I had a nylon faced mallet and gave the rear sight base a couple taps to the right. I wound up smacking it a little to far and had to drive it a little bit to the left. For now, it's shooting dead on at 25 yards.
I tried two kinds of .44 Magnum ammo in this trip. First was some of the Federal American Eagle 240 grain JHP that I bought when I got the gun. This ammo shoots OK and groups well, but does not feed smoothly. I really had to muscle the action when shooting it, which gave me some cause for concern. Having read some complaints about Marlin's quality since the Remington takeover and move to Illion, NY, I was bit worried that it might need a trip back to the factory.
However, when I switched to some Remington 240 grain JSP loads the Marlin's action worked a lot more smoothly. I figure that the Federal cases vary in some small dimension that the Marlin doesn't like. The ogives of the Remington and Federal bullets are very similar.
I've picked up a good supply of the Remington ammo so I'm set for awhile. I plan to start handloading for the Marlin so I can afford to shoot it. Also, I intend to load down the .44 Mag to .44-40 velocities, which will make it more pleasant to shoot. The Marlin has a rubber butt pad but even so, after 70 rounds of .44 Mag in a 6.5 pound rifle, my shoulder was feeling tenderized.
Overall I'm pleased with the Marlin 1894. The .44 Magnum is a versatile round, the rifle is nice, compact, and quick shooting, and of course it's got an all-American cachet. I will be adding an aperture sight at some point for faster target acquisition and better accuracy.