I hope someone can answer a question I have.
First off, I have to join in the praise of this thread. Thanks P95!
My bolt is real "sandy" feeling, rough, you all know what I'm talking about.
I just can't get the little split pin out - the one that "retains the trigger group".
I have soaked it for a while with Powderblast, taken a bit and a rubber mallet to it (somewhat gently, of course), and it doesn't seem to budge! I want to get that bolt smooth. It's driving me nuts! Any advice? (or just a link to a post about this? I skimmed through the prior posts in this thread, but I'm at work so I was in a hurry) I don't know what I would search for in the forum for such a specific problem either.
Even at this stopping point, though, I feel like I'm getting so much crud out of there. But I'd like to get the bolt good and clean.
Thanks again - Josh