I have a 91/30 Mosin Nagant, and earlier today I was cleaning the bolt and when I reassembled it, everything went back together just fine. This evening after putting about 150 rounds down range I went to clean it again, except this time when I reassemble the bolt, the firing pin doesn't protrude out like it is supposed to do. I've tried adjusting the pin, which shouldn't have to be done seeings how everything lined up perfectly earlier. No matter how much I adjust it, the pin never comes out, tried dry firing to see if it would come out, i've tried disassembling and reassembling over and over, I'm lost with this issue.