Mount a scope on a 1911 W/O drill and Tap

[Glennster]

Is there a way to mount a scope on a 1911 without drilling and tapping it?
I tried the mount that replaces the grip, I didn't care for that

I thought there was a way to mount by removing the rear sight and using that area to put a mount.
Any ideas???

 

[mscott]

Some of the slide-mounted types like a Jpoint or Fastfire seem to be O.K. They have mounting adapters to fit the rear sight dovetail.

http://www.burrisoptics.com/fastfire.html

 

[Hoser]

There arent any decent and solid ways that I would recommend short of one of the JPoint or Docter type sights.

 

[briansp82593]

heres a pic i took real fast, it works great...
http://www.cheaperthandirt.com/19114-16228-2703.html

 

[pepperbelly]

I have a B Square mount on my SA 1911. I have a C-More reddot scope on it. It uses a screw that rep-laces the slide stop pin and 2 other set screws. It is a little bit of a pain in that when I field strip the pistol to clean it I have to remove the mount. That means I have to re-zero the scope after. It is usually close enough without a re-zero to shoot my plate matches, but not close enough for my bullseye matches.
It is a good solid mount, considering that it isn't drilled and tapped. It is accurate enough tht I shot a 799 last year in bullseye. The gun and scope are capable of higher scores. I, however, need more work.

Jim