Mounting a Rockchucker

[bobhead]

I just got a Hornady L-N-L AP and I have to remount my single stage. It's an old RCBS Jr. At some point, I plan to get a Rockchucker to replace it. Before I drill holes for this JR, I was wondering if anyone can tell me the hole spacing for a Rockchucker. Both have slots for the mounting bolts so I might be able to reuse the same holes.

Thanks.

 

[maynard93]

My bolts are 3.575 center to center on my RC with a little room on either side.

 

[JackOfAllTradesMasterAtNone]

I have had both the Jr and the RC at one time or another. If I remember right, the holes line up. But one of them has three? holes? The other only 2?

-Steve

 

[bobhead]

3.575 would be at the outer edges of my JR but should work. Thanks.

 

[dmftoy1]

I just upgraded my JR to a Rockchucker a couple of months ago and I had to drill another hole. (this is keeping both in nice an tight)

Gotta love reloading equipment . . . if you buy used and reload on it for awhile you can pretty much sell it for what you bought it for.

Have a good one,
Dave

 

[flutedchamber]

Dave,

I wish I could have done that with my ex wife.....

 

[dmftoy1]

LOL . . . .Yup!

 

[Hutch]

I've had a Junior for 25+ years, and have loaded calibers up to .375H&H Mag. Never felt the need for an upgrade. I have added a Dillon XL650, but I'll be hanging on to Junior for the forseeable (sp?) future. You gonna load .50BMG or something?

 

[BigJakeJ1s]

Fluted,

Which one was that: upgrading, or selling the old one for what you bought it for?!

Andy