chutestrate
Member
I have to stop every few rounds to adjust something.
I am using lee dies with the press. Everything is misaligned. I have to guide the case into the resizer, before I complete the stroke I have to make sure the case expander is centered. The bullet seater and crimping stations go ok. I don't complete a full 100 rds without at least 10% loss of either a case, primer, or bullet.
I might as well go back to a single stage press. I'll get more done.
I'm tired of calling dillon with questions about all these little problems. The damn thing should just work after a few adjustments.
I am using lee dies with the press. Everything is misaligned. I have to guide the case into the resizer, before I complete the stroke I have to make sure the case expander is centered. The bullet seater and crimping stations go ok. I don't complete a full 100 rds without at least 10% loss of either a case, primer, or bullet.
I might as well go back to a single stage press. I'll get more done.
I'm tired of calling dillon with questions about all these little problems. The damn thing should just work after a few adjustments.
Last edited by a moderator: