What happened to the manual? Anyway these are very simple to take down.
1. Pull hammer back slowly until you hear a click, hammer will remain in position about 1/10" back ---
NOT FULLY COCKED ----!
2. Depress cylinder pin under barrel, while holding cylinder, and withdraw pin.
3. Cylinder will then come out!
Putting it back together is where a little practice is in order!
Gun should be held in the
HORIZONAL position then:
4. Step one above
5. Place cylinder in frame making sure it is level and lined up with cylinder pin hole.
6. Slide cylinder pin in place while pin is depressed, when pin is all the way to the rear and in hole in frame release pin. (
This is the Tricky part until you get the feel of it)
7. Test by checking cylinder for side play or looseness.
If loose refer back to previous step.
This whole process takes about 5 seconds once you familarize yourself with the procedure.