Need help with Beretta Neos

[BamaBarrister]

Thanks to the good folks here at THR, I found out that there was a recall on the Beretta Neos due to a firing pin problem and sent mine in for the free repair. I now have it back and took it out to fire it for the first time since the repair. It is now misbehaving and I don't know whether to chalk it up to a bad repair job on Beretta's part or something else. After most shots it takes a few seconds before you can fire it again. It's like there is a delay with the gun recocking.

Could this be the firing pin, some other sticky mechanism, or something else?
The gun has been cleaned on a regular basis but not since the repair. I am using the same ammo I have used in the past with no problems.

Thanks for any suggestions!

 

[makarovnik]

Clean it. That will force you to look for burrs, machining problems or gunk. Make sure the firing pin is not hanging up. Also check the primers on your ammo both before and after firing and try some different ammo. Good luck, those are usually nice little guns.