Herk30
Member
Ok so I'm reloading 6.8 SPC w/ 110 Accubonds. Using a Dillon 550B press, Hornady New Dimension dies. I know it has to be something simple, but it's about to make me crazy. I have all the dies set, run one case thru to set OAL and it's dead on at 2.260". Run the next case thru and it's way deep at 2.254". Back it off a just a little and it's long at 2.273". Give it tiny turns until it's right at 2.260" again, run the next case thru and it's way deep again. So I back it off, run a case thru and it's long, give it a little turn and run a while new case thru, still long but closer. So I keep adjusting the die using a new case every time until it's dead on again. Run another case and it's way off again :banghead:
Please help me out with what I may be doing wrong.
Please help me out with what I may be doing wrong.