JimGun
Member
According to my RCBS pamphlet that came with the die set, I should:
1) put a primed,powdered, casing in the shellholder and run the case up into the seater die. Then screw the seater die down until it touches the case.
2) Then back the seater die off the case for the space of about a nickel.
3) Then put a bullet in the case and run it up again.
4) Adjust the seater die plug until I have the proper seating.
My problem is that when I perform through step 3, there is not enough room in the seater die for me to screw the seater plug into it. If I put the seater plug in, it drives the bullet in so that the Overall length is 11.70 rather than 12.60, the measurement on a factory shell.
Any help is appreciated.
1) put a primed,powdered, casing in the shellholder and run the case up into the seater die. Then screw the seater die down until it touches the case.
2) Then back the seater die off the case for the space of about a nickel.
3) Then put a bullet in the case and run it up again.
4) Adjust the seater die plug until I have the proper seating.
My problem is that when I perform through step 3, there is not enough room in the seater die for me to screw the seater plug into it. If I put the seater plug in, it drives the bullet in so that the Overall length is 11.70 rather than 12.60, the measurement on a factory shell.
Any help is appreciated.