paintballdude902
Member
- Joined
- Jun 30, 2007
- Messages
- 2,872
while at appleseed this weekend one of the instructers had a 10/22 that he set into an m1 garand stock
the thing looked great (reminded me more of a reising submachine gun than an m1 but you could tell what he was going for)
the rifle had the fullsized stock on it with a new top hand guard that he said he had to make to fill in the gap for the op rod then he said that he had to make more room in the back for the 10/22 reciever the filled in some of the front with a piece of wood from and old stock(he did a great job looked like an arsenal stock repair) the rifle didnt have the front handguard or the gas tube
in order for me to stop at the same point what metal will i have to buy?
i know for sure the metal buttplate w/screws, the rear sling mount, stock ferrule and the swival
will i need the lower band and roll pin? or the hand guard ferrule?
im just going off of diagrams i found on numrich
any tips? comments?
the thing looked great (reminded me more of a reising submachine gun than an m1 but you could tell what he was going for)
the rifle had the fullsized stock on it with a new top hand guard that he said he had to make to fill in the gap for the op rod then he said that he had to make more room in the back for the 10/22 reciever the filled in some of the front with a piece of wood from and old stock(he did a great job looked like an arsenal stock repair) the rifle didnt have the front handguard or the gas tube
in order for me to stop at the same point what metal will i have to buy?
i know for sure the metal buttplate w/screws, the rear sling mount, stock ferrule and the swival
will i need the lower band and roll pin? or the hand guard ferrule?
im just going off of diagrams i found on numrich
any tips? comments?