Should I run new like .223 and .243 cases through a resizing die or are thet ready to load, i've only used new cases for my 30 Herret so I had to.
thanks
When you say "like new" do you mean brand new never fired or really clean fired cases? If they are factory new then they are ready to load, if really clean fired cases then size and check for OAL.
At the least neck size and deburr.New bulk brass in my estimation needs more case prep work than once or twice fired.This is a good time to uniform the length and deburr the flash hole.
Size, trim, deburr and chamfer, will need all of that, due to inconsistant sizing from the factory, and out of round necks from transport. It is rare I don't have to do all the above to brand new unfired brass.
Size, trim, deburr and chamfer, will need all of that, due to inconsistant sizing from the factory, and out of round necks from transport. It is rare I don't have to do all the above to brand new unfired brass.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.