Hammerheadbob
Member
- Joined
- Feb 14, 2010
- Messages
- 15
I know all have been waiting.....
My new barrel nut tool is in hand and I'll be starting a limited production run next week. If all goes right I'll have them ready for my many beta testers within two weeks....I know, I've been promising to get these out but, the design has been more difficult than I thought....still waiting on the patent pending to finalize as well.
The wait will be worth it I think....the first tool that will grab and contact EVERY tooth on the barrel nut...even with the front site tower in place. 360 degrees of contact, just as with the original HammerHead Rifle Tool...I will tell you now, this is a designated high quality barrel nut tool, 100% American Made, this is not a "multi-tool".
Bites hard, Holds Hard!
More to follow, Bob
My new barrel nut tool is in hand and I'll be starting a limited production run next week. If all goes right I'll have them ready for my many beta testers within two weeks....I know, I've been promising to get these out but, the design has been more difficult than I thought....still waiting on the patent pending to finalize as well.
The wait will be worth it I think....the first tool that will grab and contact EVERY tooth on the barrel nut...even with the front site tower in place. 360 degrees of contact, just as with the original HammerHead Rifle Tool...I will tell you now, this is a designated high quality barrel nut tool, 100% American Made, this is not a "multi-tool".
Bites hard, Holds Hard!
More to follow, Bob