New Rear Sight for 92FS

[12many]

Hello All. My new 92FS Inox shoots low and to the left and I have obtained a new rear sight (adjustable LPA) to put on the gun.

It looks easy to do, but I have been fooled before. Sometimes the things that look the easiest are not so easy.

I am pretty handy and have replaced sears and hammers before and swapped screw in sights, but nothing like this.

Is this do-able by a non professional? If so, any advice? Thanks all.

 

[12many]

Thanks to everyone who looked. I just got the part in the mail and it has instructions that come with it. It appears to be pretty easy and is indicated that it is user installable and no gun smithing required. The packaging instructions answered my question.

 

[Onmilo]

If you want to prevent the new LPA sight or the original factory sight from becoming marred during removal and installation I would recommend an inexpensive screw type sight pusher.

 

[Sheldon]

The sight can be on the slide pretty tight. I would recommend a sight pusher as well. I'm sure it can be done with a hammer and punch, but the pusher is a lot easier and less stress on everything.

Just curious what city/state are you in?? I have a MGW pusher that I used to install my LPA sight, but it takes some awkward manipulation of the pusher to install the LPA sight as the notch on the pusher is too narrow for the width of the sight.