Nylon-Tipped thumb on Hornady Concentricity Tool

[Jack B.]

Does anyone know where I can get the nylon- tipped thumb screw for their Concentricity Tool. Part # 10 on the picture on their instruction sheet? Or am I going to have to call Hornady and have them send me one?

https://press.hornady.com/assets/pcthumbs/tmp/1410991941-Instructions-Concentricity-Tool.pdf

 

[tcj]

If you call them they will likely send you one for free...I have one of their presses and they are very good about getting replacement parts out.

 

[Bandit67]

They will probably send you 2 screws if you call. They have excellent customer service.

 

[tightgroup tiger]

Mcmaster Carr has a good selection of thumb screws, if you know what thread it is.

I'd get it from Hornady also. Anyone other brand will look different and out of place since there is two more on there. (unless you want oversized knobs, you may find them at MC).

 

[Nature Boy]

If you’re looking for a replacement because the tip came off you can do what I did.

Use the cup from a spent large primer. Pick the anvil out and screw it on. Actually works better than what it came with

 

[Varminterror]

^ same here!

 

[Nature Boy]

^ same here!

Great minds

 

[Jack B.]

Just talked to Hornady and they are sending me a new one . No charge, no questions asked, glad to send me one. Hornady is one of the best companies I've had to deal with. I have found that most of the gun and reloading companies are easy to deal with. I've noticed that the people here on THR get a lot of free stuff from these companies.