stinger 327
Member
- Joined
- Sep 23, 2009
- Messages
- 3,204
On the iron sights (peep sight) on this rifle it's different than the new Mini-14's of today.
For elevation it appears there are a few white horizontal lines on a plate to line up with two screws attached.
On the windage it looks like a small allen wrench tool to move sight side to side.
What's the best way to get this sighted in without having to spend too much time or ammo to get it sighted in if possible?
Loosen one or both of the screws to move elevation up or down? It seems so tiny that one could go way overboard in trying to line up the lines or the piece of the sight may fall off when attempting to adjust.
Very tiny screws and small plate to handle.
Just got it back from Ruger because it wouldn't group before and they changed everything on rifle except the barrel.
I think the barrel got too hot so getting consistent patterns were impossible as it was going all over and off the paper target.
For elevation it appears there are a few white horizontal lines on a plate to line up with two screws attached.
On the windage it looks like a small allen wrench tool to move sight side to side.
What's the best way to get this sighted in without having to spend too much time or ammo to get it sighted in if possible?
Loosen one or both of the screws to move elevation up or down? It seems so tiny that one could go way overboard in trying to line up the lines or the piece of the sight may fall off when attempting to adjust.
Very tiny screws and small plate to handle.
Just got it back from Ruger because it wouldn't group before and they changed everything on rifle except the barrel.
I think the barrel got too hot so getting consistent patterns were impossible as it was going all over and off the paper target.