Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Pachmayr Compac grip for sp101 okay with speedloaders?

Discussion in 'Handguns: Revolvers' started by Katana8869, Jun 25, 2008.

Thread Status:
Not open for further replies.
  1. Katana8869

    Katana8869 Member

    Joined:
    Oct 1, 2006
    Messages:
    401
    I read somewhere that the Pacmayr Compac grip is not recessed for speedloaders. Is that true? I like the looks of these grips, mainly because of their length, but if I can't use my HKS speedloaders with them, I don't want to waste my money.
     
  2. coyotehitman

    coyotehitman Member

    Joined:
    Dec 29, 2007
    Messages:
    544
    If they do not work with speed loaders, it's nothing a dremel and a few minutes wont cure.
     
  3. dullone

    dullone Member

    Joined:
    Jan 31, 2004
    Messages:
    109
    Location:
    central highlands of AZ
    Trausch grips allow the use of speed loaders, and do a great job of harnessing that .357 harshness. Great grips

    http://www.trausch.com/form/accueilA.htm[/url]
     
  4. strat81

    strat81 Member

    Joined:
    Oct 6, 2006
    Messages:
    3,912
    Location:
    Nebraska
    The Compacs on my Colt D-Frame are recessed for speedloaders but the factory stocks are not.

    But that doesn't answer your question. ;)

    Did you try e-mailing Pachmayr?
     
  5. markallen

    markallen Member

    Joined:
    Aug 7, 2007
    Messages:
    425
    Location:
    NE Ohio
    I have the compac on my sp101, and they are recessed, but you still may have to trim a little. I just took a little bit off the inside edge where it contacts the frame, with an exacto knife.
    There was just enough, about an 1/16" that wouldn't allow the speedloader to sit flush on the frame, causing a little bit of binding.
     
  6. Captain Bligh

    Captain Bligh Member

    Joined:
    Dec 26, 2002
    Messages:
    267
    Location:
    Indiana
    Dunno, but I can tell you that Compacs on a S & W Model 60 get in the way of a speed loader.
     
Thread Status:
Not open for further replies.

Share This Page