Snowdog
Member
- Joined
- Dec 24, 2002
- Messages
- 4,606
I've squared away a decent recipe for my poly coated 9mm using Winchester 231, now I'm looking to load some .40S&W and 10mm.
I'm out of Winchester 231, but I have a few pounds of Power Pistol.
I've just powder coated some 145gr SWC and 175gr TC that I cast using Lee molds and Lyman #2.
With Power Pistol and these bullets, does anyone have any load data for their pet loads in either .40 S&W or 10mm?
I'll load up a few hundred .40S&W first, likely using just 145gr SWC. Then I'll move on to the 10mm using primarily 175gr TC.
The brass is once fired and Winchester (WSP/WLP) primers.
Thanks in advance!
I'm out of Winchester 231, but I have a few pounds of Power Pistol.
I've just powder coated some 145gr SWC and 175gr TC that I cast using Lee molds and Lyman #2.
With Power Pistol and these bullets, does anyone have any load data for their pet loads in either .40 S&W or 10mm?
I'll load up a few hundred .40S&W first, likely using just 145gr SWC. Then I'll move on to the 10mm using primarily 175gr TC.
The brass is once fired and Winchester (WSP/WLP) primers.
Thanks in advance!
Last edited: