I am having some issues with the RCBS trimmate. I have found that I am having to use my hand held chamfer and debur tool to properly prep my cases. The debur tool that comes with the trimmate is useless, though I did see a thread where someone attached the handheld debur to the machine one with some duct tape. That might do ok, but the chamfer is also near useless, I was still getting bullet scrapings along the mouth when I just used the machine chamfer.
Has anyone tried the VLD RCBS chamfer head on the trim mate?
Any ideas?
The machine makes it very easy to clean and uniform the prime pockets, and I added a flash hole debur tool which does fine.
Thanks for any input,
madd0c
Has anyone tried the VLD RCBS chamfer head on the trim mate?
Any ideas?
The machine makes it very easy to clean and uniform the prime pockets, and I added a flash hole debur tool which does fine.
Thanks for any input,
madd0c