I was taking them out and setting them up and i noticed in the setup guide that lee provides is different than when i set up my 9mm and .45 dies. On my 9mm and 45 it says to raise the ram and screw the bullet seating die until it touches the shell plate then turn back three full times and tighten down. On the 380 it says to put a casing in the shell plate and raise the ram, then screw down the die until it starts to make contact with the casing and tighten down. Why is that? my die is barely in my turret disk. How would it seat a bullet straight if the whole casing is outside of the die? This doesn't make sense to me can you please help. Also if this is correct, why is it different?