When installing a die the instructions say to raise the ram to the stop and screw in the die until it touches the shell holder. Question: Do you fully seat the die to the shell holder so that it's snug or do you just touch the shell holder with the die? I've seen it done both ways in videos.
If you fully seat (snug) the die to the shell holder you can hold the ram arm in place, keeping pressure on the die and tighten the die nut without holding the die to keep it from moving which I prefer.
Is the difference between the two methods enough to slightly throw off resizing, etc.,?
If you fully seat (snug) the die to the shell holder you can hold the ram arm in place, keeping pressure on the die and tighten the die nut without holding the die to keep it from moving which I prefer.
Is the difference between the two methods enough to slightly throw off resizing, etc.,?