Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Question about slugging barrels

Discussion in 'Handloading and Reloading' started by Matt Dillon, Jan 3, 2004.

Thread Status:
Not open for further replies.
  1. Matt Dillon

    Matt Dillon Member

    Joined:
    Jan 4, 2003
    Messages:
    768
    Location:
    Houston, TX
    Folks, I recently purchased a Mosin Nagant 44, and a 91/30, and a CZ 52. I needed to slug the barrels of each before starting to reload, so I lubricated each barrel, and then lulbricated and drove a buckshot ball down each barrel.
    I am asking for advice concerning interpreting my results.
    Using electronic calipers, I attempted to measure across the widest area of the buckshot, and took several readings as I rotated the buckshot between the arms of the calipers.

    The two Mosin Nagants had measurements from .307-.311, and the CZ 52 had measurements from .307-.310.

    Would I be safe using .310 or .311 bullets in the Mosin Nagants, and .308-.311 in the CZ 52?

    Thanks so much in advance for your help, Richard
     
Thread Status:
Not open for further replies.

Share This Page