the count
Member
I have 2 Wilson case gages, one for .223 and one for 9mm. I noticed that with factory ammo the rounds drop in perfectly flush. With my reloads some do and some do not (using the same die/press, etc). Note sure why that is. The ones that are not flush with the 9mm gage I further test by dropping them into a Glock 19 barrel that I took out of the gun. Most just drop in with a 'plink' sound and fire just fine.
Fast forward to the .223 gage. The ones that are not perfectly flush will not fire reliably in my AR15 but work fine in a CZ527, don't have to force the round in or anything...
So, my questions are basically whats going on here and what do I have to do with my dies so that all round fit flush into the gage....?
Fast forward to the .223 gage. The ones that are not perfectly flush will not fire reliably in my AR15 but work fine in a CZ527, don't have to force the round in or anything...
So, my questions are basically whats going on here and what do I have to do with my dies so that all round fit flush into the gage....?
Last edited: