Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RamShot True Blue powder and 380 auto

Discussion in 'Handloading and Reloading' started by tackstrp, Jun 1, 2010.

Thread Status:
Not open for further replies.
  1. tackstrp

    tackstrp Member

    Joined:
    Mar 31, 2009
    Messages:
    252
    Been shooting My KelTEC 380 P3at with 100 grain lead cast bullet. Sadly not a micro tumble lube bullet. Been using 3.5 grains of Ram Shot True Blue powder. No signs of excessive pressure. Grains used could be a little on the light side.

    Now if i could get a True Blue load data for 10MM 180 grain tumble Lube lee bullets, would be a happy shooter.

    Ram shot has a load for 40 S&W may try at the high end for the 10mm. See what happens. The 40S&W load for True Blue is 5.1 to 5.7 grains. The website is Ramshot dot com.


    Hate not being able to find tested load data from powder maker.
     
  2. Walkalong

    Walkalong Moderator

    Joined:
    Nov 20, 2006
    Messages:
    45,599
    Location:
    Alabama
    Interesting that they have 10MM data with Silhouette in their PDF, but not True Blue. Call them and ask them. They may have some data. It should work well enough in 10MM. No reason not to I would think. Enforcer as well.
     
  3. tackstrp

    tackstrp Member

    Joined:
    Mar 31, 2009
    Messages:
    252
    have eight pounds of true blue. . so need to burn

    Had to guess and trial and error with the 380 load. Will be paper target only so no need to try for hand rocket. For Carry will use Gold Dot bullets.
     
Thread Status:
Not open for further replies.

Share This Page