WhiteShark
Member
Hi there, so a common complaint that I've been hearing about when reloading is that a lot of commercial die sets will size down the neck too much, then the expander ball comes back up and expands the neck back out overworking the brass. I've heard ways around this are using bushing die sets, and or splitting up the D capping, sizing and neck sizing into separate steps.
So my real question is, will my standard RCBS 2 die set( used for AR15 reloads) leave my case neck too small/overworked? If I take out the decapping pin/expander ball will that still undersize my case neck? Also, I do not want to crimp but get proper neck tension. I'm new to this so drop that knowledge on me please.
So my real question is, will my standard RCBS 2 die set( used for AR15 reloads) leave my case neck too small/overworked? If I take out the decapping pin/expander ball will that still undersize my case neck? Also, I do not want to crimp but get proper neck tension. I'm new to this so drop that knowledge on me please.