Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RCBS primer pocket swager

Discussion in 'Handloading and Reloading' started by W.Va.Glassman, Jan 3, 2003.

Thread Status:
Not open for further replies.
  1. W.Va.Glassman

    W.Va.Glassman Member

    Joined:
    Dec 25, 2002
    Messages:
    116
    Location:
    Polk county Fl.
    What is metal cup with hole used for? I bought the set,but it has no directions.Any other suggestions?
     
  2. LarryM

    LarryM Member

    Joined:
    Dec 26, 2002
    Messages:
    1
    Location:
    Warrior, Alabama
    The cup goes between the swager and the brass so when you lower the ram on your press it will pop the brass off the swager. hope this helps Larry
     
  3. LAH

    LAH Member

    Joined:
    Jan 2, 2003
    Messages:
    799
    Location:
    In The Hardwoods
    W.Va Glassman.......What are you doing in Polk County Flordia? They tell me it's awful hot down there.
     
  4. W.Va.Glassman

    W.Va.Glassman Member

    Joined:
    Dec 25, 2002
    Messages:
    116
    Location:
    Polk county Fl.
    :p This morning it was 38 degrees HOT.I retired early from Owens-Illinois,Lakeland,Fl.Worked at the Huntington plant back in 69.Moved here in 1-71.Are you in the Charleston area?
     
  5. LAH

    LAH Member

    Joined:
    Jan 2, 2003
    Messages:
    799
    Location:
    In The Hardwoods
    We are a little closer to Beckley than Charleston. I remember well though the glass plant in Charleston.
     
Thread Status:
Not open for further replies.

Share This Page