RCBS RCii primer ?

[bomb dropper]

So I have a RCii I have the little spring loaded primer seater (if thats what its called) but I need the primer tube to hold the extra primers. I cant seem to find one that says it will work with the rc2.

Can someone point me in the right direction?

 

[Moosie]

Have you contacted RCBS? They are so good about supplying parts--often at no charge to you regardless of why damaged or missing.
moosie

 

[bomb dropper]

I guess Ill have to give them a call on Monday. it has a cut out and two set screws right in front so I imagine thats where it attaches.

 

[bigtony]

I bought one for the regular Rock Chucker and it works fine. I went to RCBS web site and the one for the RC Supreme is completely different. Go to Ebay or a reloading supplier and buy one for the Regular Rock Chucker.

 

[rcmodel]

Better yet, buy an RCBS hand primer tool and do it right from the getgo.

http://www.midwayusa.com/viewproduct/?productnumber=329291

You can prime 100 cases with one while you are busily flipping & spilling primers & filling two primer tubes for the press mounted system.

And you won't have any smashed in primers when you get done.

rc

 

[tding]

You may be refering to the RC Supreme Auto Prime which is an accessory. It's OK but I agree with rcmodel - go with the hand priming tool. However, since I only reload for hand guns I prefer the universal model which, unlike the link rcmodel showed, does not require the use of shell holders.

 

[ranger335v]

The tube you seek is/was the "automatic primer feed." It's uncommon to find them on the old models - and the RC II is old - because they worked so poorly. I tossed mine shortly after I bought it in 1986.

 

[scotty]

I have an RC II that I bought new as a kit. It came with a primer feed that, while it works fine, I have only used it with cartridges that can't be done with my Lee hand priming tool. This is rare as I have a full set of shellholders for the hand primer. If I had to buy a primer feed to fit the press, I would pass. A hand priming tool is much more convenient, faster to use and probably not any more expensive to buy.