Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RCBS shell holder in a lee?

Discussion in 'Handloading and Reloading' started by Eric F, Dec 8, 2007.

Thread Status:
Not open for further replies.
  1. Eric F

    Eric F Member

    Joined:
    Jul 23, 2007
    Messages:
    2,934
    I have a lee turet press but I am gearing up to load 50-90 and lee does not have/make a shell holder or dies for 50-90. So I found a set of rcbs dies and a shell holder. Will these work in my lee? More concerned about the shell holder I already know the dies will work.
     
  2. jhansman

    jhansman Member

    Joined:
    Mar 8, 2007
    Messages:
    981
    I use RCBS shellholders in my Lee Challenger for .357mag and .45ACP with no problems whatsoever. Should be fine.
     
  3. The Bushmaster

    The Bushmaster Member

    Joined:
    Jan 29, 2005
    Messages:
    7,868
    Location:
    Ava, Missouri
    "RCBS shell holders in a Lee?" YUP...
     
  4. ReloaderFred

    ReloaderFred Member

    Joined:
    Apr 28, 2005
    Messages:
    5,913
    Location:
    Oregon Coast
    There is more standardization in reloading equipment than just about any other type of equipment. Most of it is interchangeable, with the exception of some specialized dies and Lee shellholders for hand priming.

    Hope this helps.

    Fred
     
Thread Status:
Not open for further replies.

Share This Page