UziLand
Member
Hey All,
I have a three die set of RCBS TC 40 S&W/10mm auto dies. I have had them a long time. I don't load 40 S&W too often because I don't have one anymore. I load for friends. I was just working on some x-treme 165gr RNFP loads. I noticed that the seater plug was leaving a slight indentation ring on the bullet because the contact surface in the plug is fairly deep. The ring is about 1/10" from the tip. Doesn't break the plating or anything. I think they're ok to shoot.
Anybody else noticeed this?
Thanks, UL
I have a three die set of RCBS TC 40 S&W/10mm auto dies. I have had them a long time. I don't load 40 S&W too often because I don't have one anymore. I load for friends. I was just working on some x-treme 165gr RNFP loads. I noticed that the seater plug was leaving a slight indentation ring on the bullet because the contact surface in the plug is fairly deep. The ring is about 1/10" from the tip. Doesn't break the plating or anything. I think they're ok to shoot.
Anybody else noticeed this?
Thanks, UL