Re-profiling an Ar15 20" HBAR

Discussion in 'Gunsmithing and Repairs' started by Matrix187, Jun 29, 2009.

Thread Status:
Not open for further replies.
  1. Matrix187

    Matrix187 Member

    Joined:
    Nov 7, 2008
    Messages:
    529
    Is this possible? I've shot a few hundred rounds through the gun. I would like to have the barrel milled down to the SP1/pencil configuration. Thanks alot.
     
  2. jbaker

    jbaker Member

    Joined:
    May 10, 2009
    Messages:
    28
    Location:
    Alabama
    turn it down on a lathe or use a mill to flute it. Might be cheaper to just buy a barrel in what you want
     
  3. highorder

    highorder Member

    Joined:
    Oct 7, 2007
    Messages:
    4,350
    Location:
    Cincinnati
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice