Jasper1573
Member
- Joined
- Dec 28, 2010
- Messages
- 320
Hello all,
I am new to THR and only started reloading about 5 months ago. Up until now, I have only reloaded new or once fired Winchester brass with no issues. This week I purchased a 1000 cases of once-fired LC brass. The years on the head stamp show '06, '07, and '08. There may be others, but this is primarily what I have noticed. I have done a full length resizing on 100 of the cases. The loaded, resized, trimmed to proper length cartridge will not chamber in my Rem 700. I tried to chamber a cleaned and primed unloaded case and found that it will not chamber either, so I need some advice on how to resize these LC .308 cases. I also had this issue with some once-fired Federal cases. I am using an RCBS Rock Chucker Supreme press with standard dies.
I have researched existing threads and have been unable to find one that addresses this specific issue. This is at least one thread that discusses resizing and case shoulder issues, but it doesn't answer my question. Any advice is appreciated, and if there is a thread that answers this question, please point me to it.
Cheers,
Jasper
I am new to THR and only started reloading about 5 months ago. Up until now, I have only reloaded new or once fired Winchester brass with no issues. This week I purchased a 1000 cases of once-fired LC brass. The years on the head stamp show '06, '07, and '08. There may be others, but this is primarily what I have noticed. I have done a full length resizing on 100 of the cases. The loaded, resized, trimmed to proper length cartridge will not chamber in my Rem 700. I tried to chamber a cleaned and primed unloaded case and found that it will not chamber either, so I need some advice on how to resize these LC .308 cases. I also had this issue with some once-fired Federal cases. I am using an RCBS Rock Chucker Supreme press with standard dies.
I have researched existing threads and have been unable to find one that addresses this specific issue. This is at least one thread that discusses resizing and case shoulder issues, but it doesn't answer my question. Any advice is appreciated, and if there is a thread that answers this question, please point me to it.
Cheers,
Jasper