Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Repairing a Barlow kutmaster?

Discussion in 'Non-Firearm Weapons' started by Saakee, Jan 13, 2013.

Thread Status:
Not open for further replies.
  1. Saakee

    Saakee Member

    Joined:
    Dec 6, 2009
    Messages:
    449
    Location:
    Downtown Salem, Oregon
    I have an older knife that has a broken blade and I was hoping someone could point me toward how it could be repaired? Its mechanism is quite rough and there's some rust/corrosion on the metal.
     

    Attached Files:

  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    There are only a few people in the USA who specialize in this, and are able to make new blades and springs.

    And able to take a slip-blade knife apart and put it back together again in better condition then it was in when new.

    They are few & far between.

    Here is one advertising such services, but if he is good enough to do it, it won't be cheap.
    http://www.glenbrooksknives.com/knife-repair-restoration

    rc
     
  3. Piraticalbob

    Piraticalbob Member

    Joined:
    Jun 26, 2008
    Messages:
    480
    Location:
    Matthews, NC
  4. Saakee

    Saakee Member

    Joined:
    Dec 6, 2009
    Messages:
    449
    Location:
    Downtown Salem, Oregon
    Thanks both of you. I'll read the forum link later and contact them both soon. I don't think the knife has any sentimental value so I might just junk it depending on the cost of repair.
     
  5. CWL

    CWL Member

    Joined:
    Jan 6, 2003
    Messages:
    6,504
    Kaleb of Muskrat Man knives is excellent!

    If you want him to do the replacement blade, better hurry as his growing success is making the wait time longer & longer.
     
  6. ivankerley

    ivankerley Member

    Joined:
    May 18, 2012
    Messages:
    444
    Location:
    Cincinnati, Ohio
    short of paying someone to take it apart, secure replacement blade (donor knife, or god forbid a blade made from scratch) and clean it up, none of which will be cheap... couple options (and ive done these a few times) is thoroughly flush the knife with hot water and dish soap, working the action, see what kinda crud comes out. it should improve
    dry it completely, then oil it. You can also do an oil or wd-40 flush instead of the water.
    000 steel wool to remove rust and crud (not too aggressive but works well)
    You could regrind a blade profile, your gonna lose quite a bit but you can get a point back, however you do this make sure you dont get it so hot you cant touch it or else youll screw up the Heat Treat, i usually lower the spine side to avoid over heating the existing edge...
    It could still be usuable, just a matter of how much it means to you to rehab a busted up knife... Ive done this on a few both sentimental and just cause i felt sorry for the poor thing:D
    Whatever you decide best of luck to ya
    Gene
     
Thread Status:
Not open for further replies.

Share This Page