Surplussoldier
Member
- Joined
- Jun 19, 2006
- Messages
- 57
I shouldn't be having this problem but yet I am. I am installing a match trigger assembly into my 10/22. I have removed the stock trigger group, removing the cross-pins (B-5, I think) so that it can fall out. However, when I try to put the new trigger assembly in, this is where things get tricky.
I can, with some fidgeting, get one pin to go through, but whenever I get one pin in, the other doesn't want to go through. I can pin the front hole (very difficult) or the rear hole (easier) but the other one does not want to go through after that. Why doesn't everything just slide into place? I have been jimmying the group around as much as I can. Everything else seems to be in order. The bolt stop pin is present where it should be.
What am I doing wrong? The pins go through just fine on the trigger group itself, and through the holes in the receiver, but they just don't want to line up when I'm putting it together.
I can, with some fidgeting, get one pin to go through, but whenever I get one pin in, the other doesn't want to go through. I can pin the front hole (very difficult) or the rear hole (easier) but the other one does not want to go through after that. Why doesn't everything just slide into place? I have been jimmying the group around as much as I can. Everything else seems to be in order. The bolt stop pin is present where it should be.
What am I doing wrong? The pins go through just fine on the trigger group itself, and through the holes in the receiver, but they just don't want to line up when I'm putting it together.