Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ruger MKI vs. MKII vs. MKIII Grip Interchangability?

Discussion in 'Handguns: Autoloaders' started by tradja, Apr 16, 2008.

Thread Status:
Not open for further replies.
  1. tradja

    tradja Member

    Joined:
    Nov 25, 2006
    Messages:
    171
    Location:
    Central Oregon
    I just picked up a MKII Stainless Bull Barrel 5.5inch, with the stock black checkered grips. I’m looking at replacement grips, but I was wondering if post-'71 MKI or any MKIII grips will fit the MKII. (After reading the sticky, it seems that grips for the Standard and pre-71 MKI would not fit)

    For example, I’ve seen grips listed for the (post-’71) MKI – would these fit a MKII?
     
  2. kle

    kle Member

    Joined:
    Aug 6, 2007
    Messages:
    296
    Location:
    Virginia
    I don't think the grips for a MkI (any MkI) will fit a MkII, due to the bolt-stop on the MkII.

    I'm not certain, but I thought the MkIII grips will fit on a MkII, albeit with bits missing because of the MkIII's mag-release button being by the trigger guard, whereas the MkII's mag-release is in the heel.

    I've only got a Mk.II (soon to be two Mk.IIs), so I can't verify this...
     
  3. actionflies

    actionflies Member

    Joined:
    Apr 17, 2007
    Messages:
    163
    You can fit a hogue MKII grip in a MKIII with minor trimming of the rubber to fit the mag release button. A MKII wood grip will fit in a MKIII unless you cut a round groove to fit the mag release button.
     
Thread Status:
Not open for further replies.

Share This Page