Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

S&W Factory drilled and tapped?

Discussion in 'Handguns: Revolvers' started by bhk, Sep 10, 2008.

Thread Status:
Not open for further replies.
  1. bhk

    bhk Member

    Joined:
    Jun 17, 2006
    Messages:
    1,040
    Location:
    Wooded acreage in rural midwest
    For What!? Are you asking if your partictular revolver is drilled and tapped for a scope mount? If so, open the cylinder and look at the underside of the topstrap. If you see two holes there, your Smith is drilled and tapped fro scope mounts.
     
Thread Status:
Not open for further replies.

Share This Page