velocette
Member
I have a very nice S&W K frame . 38 spl Target Masterpiece, 5 screw, made in 1954. (forerunner of the Model 14)
It's barrel / cylinder gap is right at the outer edge at 0.008", Accuracy is good as is lockup etc.
Upon inspection, the extractor star is about .003" below the end of the cylinder.
Question, are there shims available to go between the extractor star and cylinder or are extractors available in different thicknesses?
Or am I just SOL?
Roger
It's barrel / cylinder gap is right at the outer edge at 0.008", Accuracy is good as is lockup etc.
Upon inspection, the extractor star is about .003" below the end of the cylinder.
Question, are there shims available to go between the extractor star and cylinder or are extractors available in different thicknesses?
Or am I just SOL?
Roger